Windows 8 and 8.1 have a few settings built in that mess up the plug and play nature of the HuddleCam line. These settings do exist in Windows 7 as well, but it doesn't seem to be as bad is it is on Windows 8,.81, and 10. If you have hooked up your camera but are having issues with drivers installing, your camera losing a video feed after a few minutes of video, or you are finding other USB devices not functioning correctly, these could all be caused by the Windows power saving settings. You can set all your individual USB ports to not limit their power by following the set instructions below:
Managing USB 3.0 Power Settings in Windows machines
- Global Suspend - Global suspend is only an option in Windows Vista and newer. In older Windows OS, you can
skip to step 2, below.
- Go to “Control Panel” -> “Power Options.”
- Go to “Change plan settings” on the power plan in use.
- Set “Put the computer to sleep” to “Never.”
- Go to “Change advanced power settings.”
- Set “Advanced settings” -> “USB settings” -> “USB selective suspend setting” to “Disabled”
- Click “OK” to apply settings and close.
- Individual USB Hubs and Extension Devices:
- This setting must be applied in addition to the “Global Suspend”. All hubs and extension Tx and Rx devices must have their individual power management disabled. This must be done with devices connected to the host. On Windows XP and earlier, this is the only setting to be applied, as Global Suspend (1. Above) is not an option.
- Open device manager.
- In the menu, select “View” -> “Devices by connection.”
- Select the topmost element in the list (the name of your host) and type the ‘*’ key to fully expand the entire list.
- Locate your USB 3.0 extensible host controller in the list.
- Identify the hubs, local extender and remote extender units may show up as hubs (they will be two hubs Connected together).
- Connecting a device to the extension or hub can help remove ambiguity.
- Right click on each “hub” and select “Properties.”
- Select the “Power management” tab and deselect the box labelled “Allow the computer to turn off this device to save power” and click “OK.”
- If the “Power Management” tab does not exist, the device will not be suspended and should work fine.
- Repeat step 2.g and 2.h for any hubs, local extender or remote extender units attached to the computer.
- Connect the same systems to any other 3.0 ports and repeat the above steps 2.g through 2.i, if there is a possibility that you will use other USB 3.0 ports on the PC.